|
|
ON CERTAIN KING CAB TRUCKS, THE WIRES IN THE HARNESS WERE ROUTED THROUGH THE REAR DOORS AND INTO THE BODY. THESE WIRES MAY BREAK DUE TO OVER BENDING OF THE HARNESS AS THE DOOR IS OPENED AND CLOSED. THE HARNESS CONTAINS WIRES FOR THE DRIVER SEAT BELT PRETENSIONER AND FOR THE FRONT PASSENGER SEAT BELT WHICH IS PART OF THE OCCUPANT CLASSIFICATION SYSTEM. WIRES FOR THE REAR AUDIO SPEAKERS ARE ALSO CONTAINED N THE HARNESS. ...more details
| Recall Reason |
ELECTRICAL SYSTEM |
| Recall Date |
NOV 30, 2006 |
| Model Affected |
TITAN |
| Potential Units Affected |
96500 |
|
Recall Summary
ON CERTAIN KING CAB TRUCKS, THE WIRES IN THE HARNESS WERE ROUTED THROUGH THE REAR DOORS AND INTO THE BODY. THESE WIRES MAY BREAK DUE TO OVER BENDING OF THE HARNESS AS THE DOOR IS OPENED AND CLOSED. THE HARNESS CONTAINS WIRES FOR THE DRIVER SEAT BELT PRETENSIONER AND FOR THE FRONT PASSENGER SEAT BELT WHICH IS PART OF THE OCCUPANT CLASSIFICATION SYSTEM. WIRES FOR THE REAR AUDIO SPEAKERS ARE ALSO CONTAINED N THE HARNESS.
|
|
Consequence
IF THE WIRES FOR THE SEAT BELTS AND SPEAKER WIRES BREAK AND MAKE CONTACT, THERE IS A POSSIBILITY THAT THE PRETENSIONER MAY DEPLOY. IF THIS HAPPENS WHEN THE SEAT BELT IS RETRACTED, IT WILL NOT BE POSSIBLE TO USE THE SEAT BELT. IF ONE OF THE WIRES ON THE RIGHT SIDE HARNESS FOR THE SEAT BELT TENSION SENSOR BREAKS, THE PASSENGER SIDE FRONT AIR BAG WILL NOT DEPLOY AS DESIGNED IN A FRONTAL COLLISION INCREASING THE RISK OF A CRASH AND PERSONAL INJURY.
|
|
Remedy
DEALERS WILL REPLACE THE WIRE HARNESS COVER WITH A DIFFERENT TYPE THAT PREVENTS OVER BENDING OF THE HARNESS AND THE HARNESS WILL BE REROUTED FREE OF CHARGE. THE RECALL BEGAN ON FEBRUARY 19, 2007. OWNERS MAY CONTACT NISSAN AT 1-800-647-7261.
|
|
Notes
NISSAN NORTH AMERICA, INC.
|
CERTAIN PICKUP TRUCKS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 201, "OCCUPANT PROTECTION IN INTERIOR IMPACT." AN AREA ON THE REAR PILLAR WHERE THE REAR SEAT BELT UPPER ANCHOR IS ATTACHED MAY NOT BE SUFFICIENTLY ENERGY ABSORBENT. ...more details
| Recall Reason |
SEAT BELTS:FRONT:ANCHORAGE |
| Recall Date |
JUL 19, 2004 |
| Model Affected |
TITAN |
| Potential Units Affected |
59947 |
|
Recall Summary
CERTAIN PICKUP TRUCKS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 201, "OCCUPANT PROTECTION IN INTERIOR IMPACT." AN AREA ON THE REAR PILLAR WHERE THE REAR SEAT BELT UPPER ANCHOR IS ATTACHED MAY NOT BE SUFFICIENTLY ENERGY ABSORBENT.
|
|
Consequence
THIS COULD RESULT IN AN INCREASED RISK OF INJURY IF THE AREA IS STRUCK IN A CRASH.
|
|
Remedy
DEALERS WILL REPLACE THE OUTBOARD REAR SEAT BELT ASSEMBLIES WITH NEW ONES. THE RECALL BEGAN ON SEPTEMBER 27, 2004. OWNERS SHOULD CONTACT NISSAN AT 1-800-647-7261.
|
|
Notes
NISSAN NORTH AMERICA, INC. RO406
|
ON CERTAIN CREW CAB MODEL TRUCKS, THE SEAT BACK SHAPE MAY BE SUCH THAT THERE MAY NOT BE SUFFICIENT WEBBING ON THE RETRACTOR SPOOL FOR THE REAR CENTER SEAT BELT TO RELEASE FROM THE AUTOMATIC LOCKING MODE (ALR) AFTER IT IS ENGAGED AND THE SEAT BELT IS RETRACTED. IF THIS OCCURS, THERE MAY BE DIFFICULTY IN PULLING THE SEAT BELT OUT OF THE RETRACTOR THUS PREVENTING ITS USAGE. ...more details
| Recall Reason |
SEAT BELTS:REAR |
| Recall Date |
APR 03, 2007 |
| Model Affected |
TITAN |
| Potential Units Affected |
35775 |
|
Recall Summary
ON CERTAIN CREW CAB MODEL TRUCKS, THE SEAT BACK SHAPE MAY BE SUCH THAT THERE MAY NOT BE SUFFICIENT WEBBING ON THE RETRACTOR SPOOL FOR THE REAR CENTER SEAT BELT TO RELEASE FROM THE AUTOMATIC LOCKING MODE (ALR) AFTER IT IS ENGAGED AND THE SEAT BELT IS RETRACTED. IF THIS OCCURS, THERE MAY BE DIFFICULTY IN PULLING THE SEAT BELT OUT OF THE RETRACTOR THUS PREVENTING ITS USAGE.
|
|
Consequence
IN THE EVENT OF A CRASH, A SEAT OCCUPANT MAY NOT BE PROPERLY RESTRAINED INCREASING THE RISK OF PERSONAL INJURY.
|
|
Remedy
DEALERS WILL REPLACE THE REAR CENTER SEAT BELT WITH A NEW ONE FREE OF CHARGE. THE RECALL BEGAN ON JUNE 11, 2007. OWNERS MAY CONTACT NISSAN AT 1-800-647-7261.
|
|
Notes
NISSAN NORTH AMERICA, INC. R0701
|
CERTAIN HOPKINS AFTERMARKET TRAILER BRAKE CONTROL CONNECTION HARNESSES SOLD FOR USE ON CERTAIN MODELS OF NISSAN VEHICLES WHICH ARE LISTED ABOVE. THE INTERNAL PART NUMBERS WITHIN HOPKINS ARE: 1010476025, 1040376025, 1110476025, 1170376025, 1290376025, 1010476035, 1040376035, 1110476035, 1170376035, AND 1290376035. A WIRE MAY HAVE BEEN PLACED IN AN INCORRECT POSITION IN THE ELECTRICAL CONNECTOR HOUSING. THIS RESULTS IN AN INCORRECT ROUTING OF WIRES BETWEEN THE TRAILER BRAKE CONTROLLER AND THE TOWING VEHICLE WIRING SYSTEM. ...more details
| Recall Reason |
EQUIPMENT |
| Recall Date |
JUL 03, 2007 |
| Model Affected |
TITAN |
| Potential Units Affected |
3500 |
|
Recall Summary
CERTAIN HOPKINS AFTERMARKET TRAILER BRAKE CONTROL CONNECTION HARNESSES SOLD FOR USE ON CERTAIN MODELS OF NISSAN VEHICLES WHICH ARE LISTED ABOVE. THE INTERNAL PART NUMBERS WITHIN HOPKINS ARE: 1010476025, 1040376025, 1110476025, 1170376025, 1290376025, 1010476035, 1040376035, 1110476035, 1170376035, AND 1290376035. A WIRE MAY HAVE BEEN PLACED IN AN INCORRECT POSITION IN THE ELECTRICAL CONNECTOR HOUSING. THIS RESULTS IN AN INCORRECT ROUTING OF WIRES BETWEEN THE TRAILER BRAKE CONTROLLER AND THE TOWING VEHICLE WIRING SYSTEM.
|
|
Consequence
THIS HARNESS WOULD RESULT IN POWER FROM THE TRAILER BRAKE CONTROLLER GOING TO THE TOWING VEHICLE DASH LIGHT CIRCUIT RATHER THAN THE TRAILER BRAKES. THIS RESULT WOULD BE THE LACK OF TRAILER BRAKING WHEN THE TOWING VEHICLE BRAKES WERE APPLIED. IT WOULD ALSO RESULT IN THE TOWING VEHICLES DASH LIGHTS BEING ACTIVATED WHEN THE VEHICLE BRAKES WERE APPLIED. THE FAILURE OF THE APPLICATION OF THE TRAILER BRAKE COULD RESULT IN REDUCED ABILITY TO STOP AND CONTRIBUTE TO A POSSIBLE CRASH.
|
|
Remedy
HOPKINS WILL NOTIFY OWNERS AND REPLACE THE ORIGINAL HARNESS WITH A REVISED HARNESS FREE OF CHARGE. THE RECALL BEGAN AUGUST 17, 2007. OWNERS CAN CONTACT HOPKINS AT 800-835-0129.
|
|
Notes
HOPKINS MANUFACTURING CORP.
|
ON CERTAIN PICKUP TRUCKS EQUIPPED WITH A COLUMN SHIFTER, THE SHIFT LEVER ASSEMBLY FOR THE COLUMN SHIFTER MAY HAVE BEEN DAMAGED DURING ASSEMBLY. ...more details
| Recall Reason |
POWER TRAIN:MANUAL TRANSMISSION:COLUMN SHIFT ASSEMBLY |
| Recall Date |
AUG 19, 2004 |
| Model Affected |
TITAN |
| Potential Units Affected |
5664 |
|
Recall Summary
ON CERTAIN PICKUP TRUCKS EQUIPPED WITH A COLUMN SHIFTER, THE SHIFT LEVER ASSEMBLY FOR THE COLUMN SHIFTER MAY HAVE BEEN DAMAGED DURING ASSEMBLY.
|
|
Consequence
DURING ITS USE THIS COULD EVENTUALLY RESULT IN FAILURE OF THE PORTION OF THE ASSEMBLY THAT HOLDS THE LEVER IN THE PARK POSITION. THIS COULD RESULT IN A CRASH.
|
|
Remedy
DEALERS WILL INSPECT AND REPLACE THE SHIFTER. THE RECALL BEGAN ON SEPTEMBER 27, 2004. OWNERS SHOULD CONTACT NISSAN AT 1-800-647-7261.
|
|
Notes
NISSAN NORTH AMERICA, INC. RU403
|
|