|
|
ON CERTAIN PASSENGER VEHICLES, DUE TO A MANUFACTURING PROBLEM, THE BRAKE PEDAL ARM PIVOT SHAFT COULD LOOSEN FROM ITS SUPPORT BRACKET. ...more details
| Recall Reason |
SERVICE BRAKES, HYDRAULIC:PEDALS AND LINKAGES |
| Recall Date |
JUL 24, 2002 |
| Model Affected |
X5 |
| Potential Units Affected |
34860 |
|
Recall Summary
ON CERTAIN PASSENGER VEHICLES, DUE TO A MANUFACTURING PROBLEM, THE BRAKE PEDAL ARM PIVOT SHAFT COULD LOOSEN FROM ITS SUPPORT BRACKET.
|
|
Consequence
EVENTUALLY, THE BRAKE PEDAL ARM COULD DETACH FROM THE BRACKET, RENDERING THE SERVICE BRAKING SYSTEM INEFFECTIVE, INCREASING THE RISK OF A CRASH.
|
|
Remedy
DEALERS WILL CHECK THE BRAKE PEDAL ARM PIVOT SHAFT FOR PROPER SEATING IN ITS SUPPORT BRACKET. IN ADDITION, A PIN WILL BE INSTALLED TO SECURE THE SHAFT TO THE BRACKET. OWNER NOTIFICATION BEGAN AUGUST 14, 2002. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT BMW AT 1-800-332-4269.
|
|
Notes
BAYERISCHE MOTOREN WERKE
|
VEHICLE DESCRIPTION: 4.4I SPORT UTILITY VEHICLES. THERE IS A PLASTIC CARRIER TO WHICH THE OIL FILTER HOUSING IS ATTACHED. OIL SUPPLY AND RETURN LINES ARE ATTACHED TO THE FILTER HOUSING. OVER TIME, THIS CARRIER COULD SAG SLIGHTLY. IF THIS HAPPENS, ONE OF THE OIL LINES, WHICH ARE ARMORED WITH STEEL MESH, COULD COME INTO CONTACT AND CHAFE A STEEL BRAKE LINE LOCATED IMMEDIATELY UNDERNEATH. ...more details
| Recall Reason |
SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:HOSES, LINES/PIPING, AND FITTINGS |
| Recall Date |
JUN 14, 2001 |
| Model Affected |
X5 |
| Potential Units Affected |
13721 |
|
Recall Summary
VEHICLE DESCRIPTION: 4.4I SPORT UTILITY VEHICLES. THERE IS A PLASTIC CARRIER TO WHICH THE OIL FILTER HOUSING IS ATTACHED. OIL SUPPLY AND RETURN LINES ARE ATTACHED TO THE FILTER HOUSING. OVER TIME, THIS CARRIER COULD SAG SLIGHTLY. IF THIS HAPPENS, ONE OF THE OIL LINES, WHICH ARE ARMORED WITH STEEL MESH, COULD COME INTO CONTACT AND CHAFE A STEEL BRAKE LINE LOCATED IMMEDIATELY UNDERNEATH.
|
|
Consequence
CONTINUED CHAFFING CAN CAUSE THE ANTICORROSION COATING OF THIS BRAKE LINE TO FAIL, ALLOWING THE BRAKE LINE TO RUST THROUGH AND LEADING TO LOSS OF BRAKE FLUID, FAILURE OF THE REAR BRAKE CIRCUIT, AND EXTENDED STOPPING DISTANCES, AND A POSSIBLE CRASH.
|
|
Remedy
DEALERS WILL INSTALL A RUBBER SPACER BELOW THE PLASTIC CARRIER TO PREVENT SAGGING AND SUBSEQUENT CONTACT BETWEEN THE OIL AND BRAKE LINES. BRAKE LINES WHOSE ANTICORROSION LAYER IS FOUND TO BE DAMAGED AS A RESULT OF CONTACT WITH THE OIL LINE WILL BE REPLACED. OWNER NOTIFICATION BEGAN AUGUST 14, 2001. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT BMW AT 1-800-831-1117.
|
|
Notes
BAYERISCHE MOTOREN WERKE
|
ON CERTAIN SPORT UTILITY VEHICLES, IT MAY BE POSSIBLE FOR THE FRONT BRAKE LINE TO SLIP OUT OF THE RETAINING BRACKET LOCATED AT THE FRONT STRUT. THE BRAKE HOSE THAT IS ATTACHED TO THE BRAKE LINE COULD COME IN CONTACT WITH THE TIRE AND BE SUBJECTED TO WEAR AND ABRASION. ...more details
| Recall Reason |
SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:HOSES, LINES/PIPING, AND FITTINGS |
| Recall Date |
JAN 09, 2003 |
| Model Affected |
X5 |
| Potential Units Affected |
84000 |
|
Recall Summary
ON CERTAIN SPORT UTILITY VEHICLES, IT MAY BE POSSIBLE FOR THE FRONT BRAKE LINE TO SLIP OUT OF THE RETAINING BRACKET LOCATED AT THE FRONT STRUT. THE BRAKE HOSE THAT IS ATTACHED TO THE BRAKE LINE COULD COME IN CONTACT WITH THE TIRE AND BE SUBJECTED TO WEAR AND ABRASION.
|
|
Consequence
THIS COULD INITIALLY CAUSE SOME BRAKE FLUID LEAKAGE, AND EVENTUALLY LEAD TO A SUBSTANTIAL LOSS OF BRAKE FLUID. THERE COULD BE A NOTICEABLE REDUCTION IN BRAKE PERFORMANCE IF A LOSS OF FRONT BRAKE PERFORMANCE OCCURS.
|
|
Remedy
DEALERS WILL INSTALL AN ADDITIONAL RETAINING CLIP TO FURTHER SECURE THE BRAKE LINE TO THE FRONT STRUT. ADDITIONALLY, IF INSPECTION OF ANY BRAKE HOSE INDICATES THAT IT HAS EXPERIENCED DAMAGE, THE HOSE WILL BE REPLACED. OWNER NOTIFICATION BEGAN FEBRUARY 14, 2003. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT BMW AT 1-800-831-1117.
|
|
Notes
BAYERISCHE MOTOREN WERKE
|
VEHICLE DESCRIPTION: SPORT UTILITY VEHICLES. THE LOWER STEERING SHAFT COUPLING INCLUDES A PLASTIC COLLAR WHICH FITS OVER THE LOWER STEERING RACK INPUT SHAFT. THIS COLLAR IS PUSHED DOWN ONTO THE STEERING RACK AND TIGHTENED DURING ASSEMBLY. ON SOME OF THE AFFECTED VEHICLES, THE COLLAR MAY NOT HAVE BEEN PUSHED DOWN FULLY ONTO THE RACK AT THE ASSEMBLY PLANT. ...more details
| Recall Reason |
STEERING:WHEEL AND HANDLE BAR |
| Recall Date |
JAN 18, 2000 |
| Model Affected |
X5 |
| Potential Units Affected |
190 |
|
Recall Summary
VEHICLE DESCRIPTION: SPORT UTILITY VEHICLES. THE LOWER STEERING SHAFT COUPLING INCLUDES A PLASTIC COLLAR WHICH FITS OVER THE LOWER STEERING RACK INPUT SHAFT. THIS COLLAR IS PUSHED DOWN ONTO THE STEERING RACK AND TIGHTENED DURING ASSEMBLY. ON SOME OF THE AFFECTED VEHICLES, THE COLLAR MAY NOT HAVE BEEN PUSHED DOWN FULLY ONTO THE RACK AT THE ASSEMBLY PLANT.
|
|
Consequence
OPERATION OF THE VEHICLE, ESPECIALLY IN ROUGH ROAD CONDITIONS, CAN CAUSE THE CLEARANCE BETWEEN THE COLLAR AND THE STEERING RACK TO INCREASE TO THE POINT WHERE THE INPUT SHAFT CAN SEPARATE FROM THE RACK, RESULTING IN A LOSS OF STEERING CAPABILITY.
|
|
Remedy
DEALERS WILL INSPECT THE STEERING RACK INPUT SHAFT COLLAR FOR PROPER POSITIONING, AND REPOSITION IS NECESSARY.
|
|
Notes
BAYERISCHE MOTOREN WERKE 00VX5SC01
|
VEHICLE DESCRIPTION: 4.4I SPORT UTILITY VEHICLES. OVER AN EXTENDED PERIOD OF TIME, ABRASION PARTICLES COULD DEPOSIT ON THE ELECTRICAL CONTACTS WITHIN THE SWITCH, CAUSING A DISRUPTION OF THE ELECTRIC CURRENT THROUGH THE CONTACTS. IF THE DISRUPTION OCCURS WHEN THE VEHICLE IS STATIONARY WITH THE TRANSMISSION IN THE NEUTRAL OR PARK POSITIONS, THE TRANSMISSION WILL SWITCH AUTOMATICALLY INTO THE EMERGENCY PROGRAM, WHICH IS DISPLAYED IN THE INSTRUMENT CLUSTER VIA A WARNING LAMP AND A MESSAGE, "TRANS. FAIL-SAFE PROG." IN THIS CASE, THE VEHICLE CAN BE DRIVEN IN LOWER GEARS ONLY WITH LIMITED ENGINE OUTPUT. ...more details
| Recall Reason |
POWER TRAIN:AUTOMATIC TRANSMISSION:PARK/NEUTRAL START SWITCH |
| Recall Date |
JUN 14, 2001 |
| Model Affected |
X5 |
| Potential Units Affected |
14300 |
|
Recall Summary
VEHICLE DESCRIPTION: 4.4I SPORT UTILITY VEHICLES. OVER AN EXTENDED PERIOD OF TIME, ABRASION PARTICLES COULD DEPOSIT ON THE ELECTRICAL CONTACTS WITHIN THE SWITCH, CAUSING A DISRUPTION OF THE ELECTRIC CURRENT THROUGH THE CONTACTS. IF THE DISRUPTION OCCURS WHEN THE VEHICLE IS STATIONARY WITH THE TRANSMISSION IN THE NEUTRAL OR PARK POSITIONS, THE TRANSMISSION WILL SWITCH AUTOMATICALLY INTO THE EMERGENCY PROGRAM, WHICH IS DISPLAYED IN THE INSTRUMENT CLUSTER VIA A WARNING LAMP AND A MESSAGE, "TRANS. FAIL-SAFE PROG." IN THIS CASE, THE VEHICLE CAN BE DRIVEN IN LOWER GEARS ONLY WITH LIMITED ENGINE OUTPUT.
|
|
Consequence
IF THIS PROBLEM OCCURS, THE ABILITY TO MAINTAIN SPEED IN TRAFFIC AND/OR ACCELERATE COULD BE GREATLY DIMINISHED, POSSIBLY LEADING TO A CRASH.
|
|
Remedy
DEALERS WILL REPLACE THE TRANSMISSION GEAR POSITION INDICATOR SWITCH. OWNER NOTIFICATION BEGAN AUGUST 14, 2001. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT BMW AT 1-800-831-1117.
|
|
Notes
BAYERISCHE MOTOREN WERKE
|
There are currently no photos available for 2000 BMW X5. Please try again later...
No listings available. Please try again later...
|